Energy and Renewable Energies
Abolfazl Hedayatipour; Mohsen Soleymani; Mostafa Kiani Deh Kiani
Abstract
Introduction In recent years, due to its availability and low environmental pollution, the use of Earth-Air Heat Exchanger (EAHE) has been developed as an efficient energy system in heating and cooling residential buildings and agricultural greenhouses. In this system, air is circulated by a fan through ...
Read More
Introduction In recent years, due to its availability and low environmental pollution, the use of Earth-Air Heat Exchanger (EAHE) has been developed as an efficient energy system in heating and cooling residential buildings and agricultural greenhouses. In this system, air is circulated by a fan through a pipe buried deep in the ground. Depending on the geographical location and soil type, the soil temperature at a depth of 2-3 meters remains unchanged throughout the season. Of course, this depth varies throughout the year and according to climatic changes. The heat exchange between the soil and the air inside the pipe depends on the type of soil and its moisture content, the length and diameter of the air transmission pipe, the depth of burial and the velocity of the air flow (air velocity). Air circulation can be done in an open-loop or closed-loop circuit.Materials and Methods: A factorial experiment was conducted in the form of a completely randomized block design with two factors (pipe length at three levels (34, 17 and 52 meters) and air velocity at two levels (5 and 10 m/s)) in three replications, to investigate the effect of these factors on the coefficient of performance (COP), system efficiency and outlet air temperature. The experiment was conducted in a greenhouse in Arak city, Iran, in Joune 2022. This 150 square meter greenhouse was equipped with geothermal equipment. Air was circulated through a 200 mm diameter PVC pipe buried three meters deep in the ground. Air was circulating through an open loop circuit. Dependent variables were measured during the hot hours of the day (from 12:00 to 18:00) for one week at the end of July. The air temperature at the fan inlet and at 17, 34 and 52 meters along the pipe was measured by a single-channel data logger. Hourly changes in outlet air temperature, COP and efficiency were measured in a 24-hour period and plotted using Excel software.Results and DiscussionThe outlet air temperature for the pipe length of 34 and 52 m did not change when the air velocity decreased from 10 m/s to 5 m/s. But for the pipe length of 17 m, the maximum temperature, COP and efficiency were observed at an air velocity of 5 m/s. Regardless the air velocity, the average temperature of the outlet air for the three levels of the pipe length was 28.5, 25.5 and 25.3°C, respectively. The outlet air temperature was almost the same for the 34 and 52 m pipe lengths. In other words, the optimal length of the pipe is about 34 meters. The mean efficiencies for these two pipe length levels were 0.69 and 0.66, but the COP depended on the air velocity. The average COP for air velocity of 5 and 10 m/s was obtained 1.4 and 2.5, respectively. Based on these results, the best performance of the system in terms of output temperature reduction, cooling efficiency and COP is obtained in situation that the length of the pipe is 34 m and the air velocity is 10 m/s. when the length of the pipe is 17 meters, the temperature of the air outlet at two velocities of 10 and 5 m/s was 29.9 and 27 °C, respectively. The cooling efficiency and COP at two velocity of 10 and 5 m/s, were 0.34, 0.54; and 2.1, 1.7 respectively. If the desired temperature is 28-30 °C, pipe length of 17 m and the air velocity of 5 m/s is recommended. The results of hourly performance analysis showed that the highest difference between inlet and outlet air temperatures, is obtained at middle hours of the day. The higher the ambient temperature, the higher the efficiency of the EAHE system. ConclusionThis system successfully met the cooling needs of a model greenhouse in the weather conditions of Markazi Province in June. Based on the results, the optimal pipe length and air velocity were obtained as 34 m and 10 m/s, respectively. The average air outlet temperature and cooling efficiency were 25.5, 0.66 and 2.5 respectively. The higher the ambient temperature, the higher the EAHE efficiency. This is mainly due to the higher temperature difference between the outgoing and incoming air during the hottest hours of the day. As a result, system efficiency and COP increase at the hottest hours of the day.
